Servo hidraulik Silinder berat

The HOB hydraulic cylinder is usually composed of a cylinder block, a cylinder rod (piston rod) and a seal. The inside of the cylinder block is divided into two parts by the piston, each passing through an oil hole. Because the compression ratio of the liquid is very small, when one of the oil holes enters oil, the piston will be pushed to make the other oil hole discharge oil, and the piston drives the piston rod to extend (retract), and vice versa.

All SVG cylinder pockets must have sufficient drainage to allow oil to flow out the bottom of the tool in the event of a hydraulic line leak .

The familiar structures of longgar core and ejector of hydrocylinder in injection mold were introduced . The calculating method of selecting hydrocylinder and the key points in using it were discussed .

Our heavy duty mold cylinder provide uniform results under repeat severe use. Molds are split on one side and secured with

All molds are furnished with a detachable base made from ¼” steel plate. All steel mold components are plated to resist rust.

Our main products include Hydraulic Cylinder, Hydraulic System, Hydraulic Valve, Hydraulic Pump and Hydraulic Accessories.